Usb Application Without Usb Suspend Function - Quectel EG91 Series Hardware Design

 Execute AT+QSCLK=1 command to enable sleep mode.
 Ensure the DTR is held at high level or keep it open.
 The host's USB bus, which is connected with the module's USB interface, enters into suspended state.
The following figure shows the connection between the module and the host.
 Sending data to EG91 through USB will wake up the module.
 When EG91 has a URC to report, RI signal will wake up the host.
3.5.1.4.

USB Application without USB Suspend Function

If the host does not support USB suspend function, USB_VBUS should be disconnected with an external
control circuit to let the module enter into sleep mode.
 Execute AT+QSCLK=1 command to enable sleep mode.
 Ensure the DTR is held at high level or keep it open.
 Disconnect USB_VBUS.
The following figure shows the connection between the module and the host.
Figure 6: Sleep Mode Application without Suspend Function
EG91_Hardware_Design
Module
USB_VBUS
USB_DP
USB_DM
AP_READY
RI
GND
Figure 5: Sleep Mode Application with RI
Module
Power
USB_VBUS
Switch
USB_DP
USB_DM
RI
AP_READY
GND
LTE Standard Module Series
EG91 Hardware Design
Host
VDD
USB_DP
USB_DM
GPIO
EINT
GND
Host
GPIO
VDD
USB_DP
USB_DM
EINT
GPIO
GND
29 / 93