Assembly - Yardworks 060-2279-2 Owner's Manual

WARNING!
Before assembly, make sure that the tool is switched off and unplugged.
Fitting the guard (See Figure 2 & Figure 3.)
1. Secure the guard with 3 screws.
2. Place the safety guard onto the motor housing as shown, pivot the guard anti-clockwise to the position of
figure 3. Secure the guard with the screw.
WARNING!
Never use the tool unless the guard is properly fitted.
Fitting the secondary handle (See Figure 4 & Figure 5.)
1. Place the handle on the tool as shown.
2. Adjust the handle to the most comfortable position. Use the marking as a guide.
3. Pass the bolt through the secondary handle and the main handle.
4. Screw the nut into the other side of the bolt. Do not over-tighten the bolt.

Assembly

8