Yardworks 060-2279-2 Owner's Manual page 13

Winding new line onto a spool (See Figure 18 & Figure 19 & Figure 20.)
1. You may wind new cutting line onto an empty spool.
2. Replacement packs of cutting line are available from dealer.
3. Remove the empty spool from the tool as described above.
4. Remove any remaining cutting line from the spool.
5. First feed 10 cm of cutting line (7) into two eyelets, one eyelet (8) in the upper section of the spool as
shown, the other eyelet in the lower section not shown, but still proceeding in the same manner as shown
for the upper section.
6. Wind the cutting line onto the spool in the direction of the arrow (9). Make sure to wind the line neatly and
in layers. Do not criss-cross.
7. Feed cutting line (7) into the two parking slots (10) in the upper section of the spool as shown, the other
two parking slots in the lower section by proceeding in the same manner as shown for the upper section.
8. Finish winding and proceed as described above to fit the spool on the device. Do not forget to release
the cutting line from the parking slot.
WARNING!
Only use the appropriate type of cutting line.
13