Installing The Chassis In A Two-Post Rack - Cisco Nexus 93360YC-FX2 Hardware Installation Manual

Installing the Chassis
1 Center-mount bracket with its larger side facing the
chassis and the longer side facing the front (port side)
of the chassis. Align four screw holes in the bracket
to four screw holes in the side of the chassis.
Step 2
Use four M4 x 8 mm screws to attach the bracket to the chassis. Tighten each screw to 11 to 15 in-lb (1.2 to 1.7 N·m).
Step 3 Repeat Steps 1 and 2 to attach the second center-mount bracket to the other side of the chassis.
What to do next
You are ready to mount the chassis to the two-post rack.

Installing the Chassis in a Two-Post Rack

You need to position the chassis near the top of the rack with the power supply and fan modules in the
appropriate aisle for their required airflow. If the fan modules have a blue coloring for port-side exhaust
airflow, then you must position the modules by the cold aisle. If the fan modules have a burgundy coloring
for port-side intake airflow, you must position the modules by the hot aisle.
Note Power supply modules must have the same airflow direction as the fan modules.
Warning Statement 1074 Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Warning Statement 1032 Lifting the Chassis
To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the handles
on modules (such as power supplies, fans, or cards); these types of handles are not designed to support the
weight of the unit.
2 Four M4 x 8 mm screws used to fasten the bracket to
the chassis.
Cisco Nexus 93360YC-FX2 NX-OS Mode Switch Hardware Installation Guide
Installing the Chassis in a Two-Post Rack
19