Installing A 1 (Ru) Chassis In A Two-Post Rack - Cisco Nexus 3400 Series Hardware Installation Manual

Installing the Chassis
1 Fasten the chassis to the front of the rack with two
12-24 or 10-32 screws on each side.
2 Front-mount bracket.
d) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).
Step 6
If you attached a grounding wire to the chassis grounding pad, connect the other end of the wire to the facility ground.

Installing a 1 (RU) Chassis in a Two-Post Rack

This section describes the rack installation for the Cisco Nexus 3000 series switch into a two-post rack.
To install a switch, you must attach mounting brackets to the switch and secure the switch to the rack.
Installation in racks other than 19-inch racks requires a bracket kit not included with the switch.
The following figure shows the standard 19-inch mounting brackets.
Installing a 1 (RU) Chassis in a Two-Post Rack
3 Mounting rails on rack or cabinet posts.
Cisco Nexus 3400 Hardware Installation Guide
19