Cisco Nexus 93360YC-FX2 Hardware Installation Manual page 30

Installing the Switch using the NXK-ACC-RMK-2RU Rack-mount Kit
• If the switch has port-side exhaust modules (fan modules with blue coloring), position the front-mount brackets
so that the switch fan and power supply modules will be in the cold aisle.
b) Position a front-mount bracket so that it aligns to the desired position in the rack and secure the bracket with 12-24
screws or 10-32 screws, depending on the rack thread type (see the following figure). Tighten 12-24 screws to 30
in-lb (3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque..
c) Repeat Step 1 for the other front rack-mount bracket on the other side of the rack and be sure to position that bracket
horizontally to the same level as first bracket.
Step 2 If you are not installing the chassis into a grounded rack, you must attach a customer-supplied grounding wire to the
chassis as explained in
can skip this step.
Step 3
Install the slider rails on the rack or cabinet as follows:
a) Determine which two posts of the rack or cabinet you should use for the slider rails. Of the four vertical posts in the
rack or cabinet, two will be used for the front mount brackets attached to the easiest accessed end of the chassis, and
the other two posts will have the slider rails.
b) Position a slider rail at the desired level on the back side of the rack and slide it into the front-mount bracket already
installed and secure with 12-24 screws or 10-32 screws, depending on the rack thread type (see the following figure).
Tighten 12-24 screws to 30 in-lb (3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.
Cisco Nexus 93360YC-FX2 NX-OS Mode Switch Hardware Installation Guide
22
Grounding the Chassis, on page 32. If you are installing the chassis into a grounded rack, you
Installing the Chassis