Begin With An Existing Experiment - Fluidigm Polaris User Manual

Setting Up the Experimental Run

Begin with an Existing Experiment

shortest possible dosing or feeding interval is 20 minutes, and the longest is 24
hours.
• No Treatment. In a No Treatment experiment, the Cell Selection step is followed
immediately by the Post Stain/Wash step, by-passing the Dose and Feed or Time
Course step entirely.
4 You are now ready to enter the experimental profile, beginning with
Overview on page 19 and continuing with each step in the workflow.
Begin with an Existing Experiment
1 Tap the Fluidigm logo at the bottom-left of the touchscreen:
2 When you see the Polaris menu on the left panel, tap View Runs.
3 On the Select a run to view screen, you can see your previous experimental setups
and export completed run data (including capture annotation, intensities, and
images).
The latest runs are on display in the touchscreen. Use the locater bar to display the
experimental run of your choice. For example:
The most current run is located at the far left, and all previous runs follow to the right.
Either use your fingers to swipe to the right or left or tap any of the navigation bars,
and then swipe to the right or left to display the experiments that reside within that
set.
This example contains 40 runs. Run 1 is the most current run (on display at the far left
of the touchscreen) and run 40 is the oldest run (at the far right of all the runs).
4 Tap an experiment that you want to clone.
5 Tap Clone.
6 On the Experiment details screen, you can edit the existing experimental profile,
and then tap Start to run the experiment.
7 You are now ready to edit the existing experimental profile, beginning with
the Overview and continuing with each step in the workflow.
18
Set Up the
Set Up
Polaris: User Guide