Teaching In To A Homematic Ccu - HomeMatic HM-LC-Sw1-Pl-2 Operating Manual

device LED will flash continuously to indicate that teach-in
mode is active. The teach-in time is 20 seconds.
• Now put the device you wish to teach-in the actuator into
teach-in mode. Please follow the relevant operating manual
instructions of the corresponding device.
If no teach-in is carried out, teach-in mode will be exited
automatically after 20 seconds. If other devices are also in
teach-in mode, they will be taught-in.
6.2.2

Teaching in to a HomeMatic CCU

Your device can be conveniently
• controlled and configured,
• connected directly to other devices or
• used in central control programs
via the HomeMatic software „WebUI". Therefore, your actuator has
to be taught-in to the HomeMatic Central Control Unit first. New
devices are taught-in to the Central Control Unit via the HomeMatic
„WebUI".
A soon as a component has been taught-in to a Central
Control Unit, it can only be connected to other components via
the CCU.
Each component can only be taught-in to one Central Control
Unit.
During teach-in, please make sure you maintain a distance of
at least 50 cm between the HomeMatic devices and the
Central Control Unit.
To teach-in your device to the Central Control Unit, proceed as
follows:
• Open the „WebUI" user interface in your browser.
22
• Click the „Teach-in devices" button on the right-hand side of
the screen.
• To activate teach-in mode, click „BidCoS-RF teach-in mode" in
the next window.
• Teach-in mode remains activated for 60 seconds. An informati-
on box shows how much teach-in time remains.
• Meanwhile, please activate the teach-in mode of the actuator
to teach-in as well.
• Therefore, press and hold down the channel button for at least
4 seconds. The device LED will flash continuously to indicate
that teach-in mode is active.
• After a short time, the newly taught-in device will appear in
the inbox of your software interface. The button „Inbox (x new
devices)" indicates how many new devices have been taught-
in successfully.
• If required, you can teach-in additional devices by repeating
the steps described above for each device.
• Now configure the newly taught-in devices in the inbox as
described in the next section.
Configuring newly taught-in devices
Once you have taught-in your actuator to the HomeMatic Central
Control Unit, it will be moved to the inbox. Here, you must confi-
gure the device and its associated channels in order to make them
available for operating and configuration tasks. Give the device a
name and assign it to a room. You can also make individual para-
meter settings.
Now you can use the „WebUI" user interface to control your device,
configure it, link it directly to other devices, or use it in central con-
trol unit programs. Please refer to the HomeMatic WebUI manual
23