Advertisement
2 SETUP
6
(Super Duke GT US)
–
Bond the reflectors on the right and left side of the reflec-
tor holder.
–
Mount the reflector holder on license plate holder
Guideline
Remaining screws,
chassis
S03373-10
–
Remove the cable ties of the rider footrests.
–
Carefully loosen and remove the tension belt from the frame.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tension belts around the fork
legs.
The vehicle is released at the front.
S03377-01
–
Together with an assistant, take the vehicle off the pallet.
–
Remove the radiator shield.
–
Remove passenger seat. (
Info
The Race-on key is located in the left storage compart-
ment.
–
Remove spare key and KEYCODECARD and keep in a safe place
for the handover.
–
Secure tool set with the rubber strap.
E00273-01
–
Place on the vehicle and adjust both rear mirrors in a horizon-
tal position.
–
Check minimum spacing
shield after the handlebar has been driven in fully.
Guideline
Minimum spacing
between the mirror bar and
windshield
S03213-11
»
If the spacing
below the minimum:
–
Adjust the steering angle. (
–
Make sure that there is sufficient space between the controls
and fuel tank when the handlebar has been driven in fully after
completing the work.
M6
10 Nm (7.4 lbf ft)
p. 8)
C
between the mirror bar and wind-
9 mm (0.35 in)
C
C
between the mirror bar and windshield is
p. 10)
8
.
Advertisement
