Usb Device Testing - Embest SBC8600B Quick Start Manual

Note:
 The system can mount the TF card automatically when you insert it on the
board. However, we recommend mounting it manually because automatic
mounting may lead to a slow writing speed.

6.8.7 USB DEVICE Testing

USB DEVICE testing is accomplished by using a cable to connect the
miniUSB interface of the development board to the USB interface on a PC;
the development board is recognized by the PC as a network device so the
two ends may communicate by Ping command.
1. After system boot-up, please use a USB cable to connect the
development board to your PC. The Linux USB Ethernet driver
needs to be installed on PC. Please refer to 7Appendix 2:Driver
Installation Of Linux USB Ethernet/RNDIS Gadget for detailed
information
2. Execute the following commands in
root@SBC8600:~# ifconfig usb0 192.168.1.115
root@SBC8600:~# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:26 errors:0 dropped:0 overruns:0 frame:0
TX packets:26 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2316 (2.2 KiB) TX bytes:2316 (2.2 KiB)
usb0 Link encap:Ethernet HWaddr 5E:C5:F6:D4:2B:91
inet
Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:253 errors:0 dropped:0 overruns:0 frame:0
TX packets:43 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:35277 (34.4 KiB) TX bytes:10152 (9.9 KiB)
3. After the development board is configured, please click My
Computer >
Connection, a virtual network adapter will be added into the PC.
addr:192.168.1.115
Network Neighbourhood
the HyperTerminal:
Bcast:192.168.1.255
> Check Network
Page | 63