Setting Up The Camera Using The Mac Address On The Setup Program - Panasonic CQ-DF602U Operating Instructions Manual

• If "Camera setup completed" is displayed, click [Close] to finish the
Manual Setup.
3.
Close all Setup windows.
Setting up the Camera Using the MAC Address on the Setup
Program
The Setup Program may not list any cameras due to your firewall or antivirus
software settings on your PC. If you cannot disable your firewall or antivirus
software, you can set up the camera using the camera MAC address as shown
below.
1.
Enter the camera MAC address in the data field, and click [Set up camera].
Note
• The camera's MAC address can be found on the sticker affixed to the
bottom of the camera (see page 9 for BB-HCM381A or page 11 for
BB-HCE481A).
2.
After confirming the network settings, click [OK].
• After about a minute, the Security: Administrator page is displayed.
Operating Instructions
183