Panasonic CQ-DF602U Operating Instructions Manual page 105

Setting
How to
authenticate
*1 Note that [Space], ["], ['], [&], [<] and [>] are not available.
*2 Note that ["] is not available.
The authentication method can be selected:
[No authentication], [POP before SMTP authentication] or
[SMTP authentication].
POP server authentication may be required by your ISP. In
that case, set POP before SMTP authentication.
• No authentication: No authentication when sending an e-
mail.
• POP before SMTP authentication: Some SMTP servers
that send e-mails do not have an authentication feature.
Therefore, the camera uses the authentication of a POP
server that receives e-mails, before sending e-mails.
– POP3 Server IP
Address or Host
*1
Name :
– Port No.:
*2
– Login ID :
*2
– Password :
• SMTP authentication: Users are authenticated by user
name and password on the SMTP server. Your ISP must
support the SMTP authentication. The supported SMTP
authentications of the camera are the LOGIN and PLAIN
authentications.
*2
– Login ID :
*2
– Password :
Description
If you set a server IP address, set
4 numbers (0—255) and 3
periods, such as "192.168.0.253".
Note that "0.0.0.0" and
"255.255.255.255" are not
available. Or set a host name (0—
255 characters).
You can set an IPv6 address.
Enter a number (1—65535).
Usually set to 110.
If your ISP requires a login ID to
log in to a POP3 server, set it (1—
63 characters).
If your ISP requires a password to
log in to a POP3 server, set it (0—
63 characters).
If your ISP requires a login ID to
log in to an SMTP server, set it
(1—63 characters).
If your ISP requires a password to
log in to an SMTP server, set it
(0—63 characters).
Operating Instructions
105