Festo CPV10-GE-ASI-4E3A-Z M8 Brief Description page 17

3 Installation instructions
3.1 AS−Interface Addresses
Before connecting to the AS−Interface bus: assign an un
used address to each slave.
Address assignment
The assignment of the data bits to the inputs and outputs
of the slave shows the following figure:
Data bits:
Inputs:
Outputs:
E/A = bi directional (B)
The address mapping depends on the configuration of the
master.
3.2 Assigning the AS−Interface address
Please note
Addressing valve terminal type CPV..−GE−ASI−4E3A−Z is
only permitted with addressers as per specification 2.1.
Other addressers do not permit clear access to the
slaves and in some cases overwrite the ID1 code.
Recommendation: Use the Festo addresser type ASI−PRG−
ADR with adapter cable type KASI−ADR.
Festo CPV..−GE−ASI−4E3A−... 0404NH English
IO code 7
H
D0 D1 D2 D3
I/O I/O I/O I/O
I0 I1 I2
O0 O1 O2
I3
17