Management Choices - Aastra TA7102i Hardware Installation Manual

•
To trigger the Factory Reset:
1. Power the TA7102i off.
2. Insert a small, unbent paper clip into the Reset / Default hole located at the rear of the
TA7102i. While pressing the Reset / Default button, restart the unit. Do not depress before
the LEDs stop blinking and are steadily ON.
3. Release the paper clip. The TA7102i restarts. This procedure resets all variables in the MIB
modules to their default value. When the TA7102i has finished its provisioning sequence, it
is ready to be used with a DHCP-provided IP address and MIB parameters. This procedure
can also be performed at run-time.
Note: The Factory reset alters any persistent configuration data of the TA7102i.

Management Choices

4.4
Congratulations for properly installing the TA7102i. You can now configure the software
parameters of the unit.
The TA7102i offers various management options. All these options are described in the Dgw
v2.0 Software Configuration Guide.
Table 8: Management Options
Management
Choice
Web GUI
SNMPv1/2/3
Command Line
Interface (CLI)
Unit Manager
Network
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24
Features
The TA7102i web interface allows you to configure the following
information:
• Network attributes
• SIP parameters
• VoIP settings
• Management settings such as configuration scripts, restore /
backup, etc.
The TA7102i SNMP feature allows you to configure all the MIB
services.
The TA7102i CLI feature allows you to configure all the MIB
services.
The UMN offers the following:
• Auto-discovery
• Group provisioning
• SNMP access and remote management.
33
TA7102i Hardware Installation