Page 3
Note: CNX release 1.3 and earlier must not be loaded onto Rev07 or newer units due to firmware incompatibility that will result in failure of the system to boot. CNX 1.3p1 or later must be used on these units. RN-001031-00, Rev 00 Rel. 1.3p1...
The Aastra CNX software is packaged in a single file called “full_cnx.dra”. This file will update both the CompactFlash and the onboard flash firmware. You can place the full_cnx.dra file on your PC and use the Update CNX Software button to install the update.
Aastra CNX. Click the Aastra CNX. Note: The Aastra CNX requires approximately 35 MB or more of free disk space for an upgrade. and verify that there is sufficient disk space to upgrade RN-001031-00, Rev 00 Rel. 1.3p1...
Page 7
Step Action In the “Status” section, click Result: The following prompt displays. Enter the location of the full_cnx.dra file in the text box. Click The Select File window displays. Navigate to the location of the full_cnx.dra file and click OPEN to automatically place it in the text box of the Browse window.
Page 8
15 minutes to fully update the onboard flash firmware and the compactflash root filesystem. You will be unable to log into the CNX webinterface until the upgrade is fully complete. Progress can be monitored using the serial console, if connected. When the upgrade is complete, the following message displays on the console: “Upgrade of the Aastra CNX is complete”.
Page 9
There is sufficient disk space for the operation of the Aastra CNX. Note: The Aastra CNX requires approximately 35 MB or more of free disk space to operate properly. If there is insufficient disk space, click “CLEANUP CNX” to delete unwanted files on the CompactFlash.
Page 12
Aastra CNX Conference Network Switch 1.3p1 Release Notes Published in the USA RN-001031-00 Rev 00 Aastra CNX Conference Network Switch Release 1.3p1 February 2007...
Need help?
Do you have a question about the CNX and is the answer not in the manual?
Questions and answers