Reset/Default Button - Aastra TA7102i Hardware Installation Manual

LED Patterns – Default Behaviour
When no specific condition matches those described in Table 5, the LEDs behave individually
according to the following rules:
Table 6: Default LED Behaviour
LED Type
Power
ETH
In Use
Ready

RESET/DEFAULT Button

4.3
The RESET/DEFAULT button allows you to:
•
Cancel an action that was started.
•
Revert to known factory settings if the TA7102i refuses to work properly for any reason or
the connection to the network is lost.
3. Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time – you can press the button while the
TA7102i
is running without powering the unit off. Table 7 describes the actions you can perform in this
case.
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24
Condition
RestartInProgress
RestartCompleted
Network traffic
No network traffic
Lines Idle and Unlocked Steady OFF
Lines InUse and
U l k d
Shutting Down
Locked
All lines are enabled
(operational state).
All lines are disabled
(operational state).
At least one line is
enabled and at least
one line is disabled
29
TA7102i Hardware Installation
Behaviour
Blinking, 1 Hz, 50% duty
Steady ON
Blinking, variable rate
Steady ON
Steady ON
Steady yellow
Blinking yellow, 1 Hz, 50% duty
Steady ON
Steady OFF
Blink 0.25 Hz 75%