Status And Message Lines (Cont'd) - 3D Systems ProJet 3500 Max Series User Manual

STATUS AND MESSAGE LINES (CONT'D)

MESSAGE
PRE-JOB CHECKS
BUILDING
RAISING PRINTHEAD
REMOVE BUILD
SHUTDOWN IN PROGRESS
SHUTDOWN COMPLETE
STANDBY
WAITING FOR JOB
WARMING STAGE [4,3,2,1]
3D Systems, Inc.
CAUSE
• Briefly displayed during printer build preparation
• The printer is currently building .
• The printer is raising the printhead so you can
remove the platform .
• The chamber door is open .
• You selected the SHUTDOWN MODELER menu
option, then pressed YES twice . The printer is
cooling down so power can be switched off . Refer
to printer shutdown .
• Printer cool down is complete; printer is ready for
power off .
• The printer is in energy-saver mode . All internal
subsystems are partially cooled and the printer is
inactive .
• The printer is online, but there is no build job in it's
queue . The printer is ready to build as soon as it
receives a job .
• The material heaters and printhead jet heaters
gradually warm up to either standby or build tem-
perature .
62
ACTION
None .
Allow the build job to continue or
press PAUSE or STOP to stop
building .
None . (This occurs automatically
before every build .)
Remove the platform and replace
it with a clean platform . Refer to
removal of build platform .
None . DO NOT switch off the printer
while shutdown is in progress .
Wait for OK TO POWER OFF
message, then switch power off at the
printer's rear panel .
None . The printer will warm to
operating temperature when you
press any button or submit a build job .
Submit a build job to the printer . Refer
to submit a build job .
None . The numbers on the
Operator's Panel displays the count
down as the printer warms up .
At Warming Stage 1, all heaters and
material are at build temperature .