Child Restraint System - Cirrus SR22 Pilot Operating Handbook

C D
IRRUS ESIGN
SR22
To Use Restraints
No slack may exist between the occupant's shoulder and restraint
Stow the seat belts in the latched position when not in use.
1. Slip arms behind the harness so that the harness extends over shoul-
ders.
2. Hold the buckle and firmly insert the link.
3. Grasp the seat belt tabs outboard of the link and buckle and pull to
tighten. Buckle should be centered over hips for maximum comfort
and safety.
4. Restraint harnesses should fit snug against the shoulder with the lap
buckle centered and tightened around the hips.
To Release Restraints
1. Grasp the top of the buckle opposite the link and pull outward. The
link will slip free of buckle.
2. Slip arms from behind the harness.

Child Restraint System

To Install Child Seat
The aircraft is equipped with provisions for installing two LATCH
compliant child seats in the outboard rear seat positions, OR one
non-LATCH compliant seat in the center rear seat position.
Lower anchors for the LATCH compliant seats are located in the outboard
seat positions. The non-LATCH compliant seat must be installed using the
center seat belt. Three top tether anchors for the child seats are located on
the rear bulkhead.
1. Fasten lower seat attachments to bench seat:
a LATCH Compliant Outboard Seat: Fasten lower seat attachment
to the outboard anchors in the bench seat.
b Non-LATCH Compliant Center Seat: Using the center seat belt,
fasten lower seat attachments to the bench seat as described by the
manufacturer's instructions.
2. Locate top tether pass-through - a narrow slit in the seat back uphol-
stery - near the top, outboard section of the seat back.
Do not route child seat top tether over or around seat back. The
top tether must be routed through the seat back pass-through for
P/N 13772-006
Reissue A
• CAUTION •
harness shoulder strap.
• CAUTION •
the child seat to function properly.
S 7: A
ECTION IRPLANE AND
S B S
EAT ELT AND HOULDER
S
YSTEMS
H
ARNESS
7-29