Elite ProAV Manual Grande 2 Series User Manual

Thank you for choosing the Manual Grande® 2 Series projection screen! This large size manual pull-down screen includes
our GREENGUARD GOLD® and ISF Certified MaxWhite® 2 front projection material. The MaxWhite® 2 best
performs under a light controlled environment since it is a matte white surface.
Note: Wall screws included with this product are complimentary and may not be adequate for all mounting surfaces.
Consult with a professional installer or hardware store for proper mounting screws and anchors.
Regardless of the mounting method, the screen should be securely supported so that the vibration or pulling on the
viewing surface will not cause the screen case to become loose or fall. The installer must ensure that proper mounting
hardware and the fasteners used are of adequate strength and suitable for the mounting surface.

Screen Installation

Note: 2 or more people are required for a safety installation.
1. Determine where the screen will be installed. Mark the screw hole locations for the brackets at the desired height.
2. Drill the holes and insert the dry-wall anchor (E) if not installing directly to a wood stud. Otherwise use the wood
screw and install the brackets.
Note: Brackets should be fastened to wall studs. Concrete or brick walls require special fasteners/anchors and
are not included.
3. Once the brackets have been properly installed and leveled, hang the screen as illustrated below. Be sure the case
is fully seated on the bracket and slide it into position if needed to complete the installation.
11212019JA
A. Wall/Ceiling B. Eyebolt
Bracket x 3 pcs x 3 pcs

A. Flush Wall Installation

2. Insert the top of the case into the bracket's top plate.
1. Secure the screen's top/bottom case
hook to the mounting bracket's cleat.
Large-Venue Manual Pull-Down Projection Screen

Hardware Parts List

C. Washer D. Nut x 6
x 6 pcs pcs
www.eliteproav.com
Manual Grande® 2 Series
USER'S GUIDE
E. Screw and Dry-wall
anchor x 6 sets
(for mounting screen)
1