Maintenance - Husqvarna PG 830S Operator's Manual

Introduction
WARNING: Before you do maintenance, you
must read and understand the safety
chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
To do before the maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Use approved respiratory protection. The dust from
the product is dangerous to your health.
• Park the product on a level surface.

Maintenance

Do a check of the ON/OFF switch.
Do a check of the attachment points and the lock function for the handle.
Do a check of the attachment points and the lock function for the
weights.
Do a check of the emergency stop button.
Clean the external surfaces of the product.
Clean the internal components of the product.
Do a general inspection.
Do a check of the grinding discs.
Do a function check of the drive system for the grinding head.
Do the service on the drive system for grinding discs.
Do a check of the connection between chassis and grinding head.
To clean the product
CAUTION: A blocked air intake decreases
the performance of the product and can
cause the motor to become too hot.
• Remove blockage from all air openings. The product
must always have sufficiently cool temperature.
• Always disconnect the power plug from the mains
outlet before you clean.
• Do not use chemicals to clean the product.
• Do not clean electrical components with water.
18
Maintenance
• Stop the motor and disconnect the power plug to
prevent accidental start during maintenance.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
• Always clean all the equipment at the end of the
work day.
a) Tilt the product until the handlebar is on the floor.
b) Remove the diamond tools and operate the
product for a short period at the lowest speed.
Operate the product to decrease the quantity of
dust at the top surface of the grinding head.
c) Clean the components at the bottom surface of
the grinding head with a high-pressure washer.
Each 6
Daily Weekly
months
*
*
*
X
X
O
X
X
X
*
1253 - 003 - 22.01.2020
Each
12-36
months
O