Husqvarna PG 830S Operator's Manual page 17

2. Install the 2 weight brackets. Make sure that the
weight brackets are installed correctly as shown in
the illustration.
3. Put the weight on the cylinder (A) on the weight
holder.
4. Attach the weight gas spring to the product (B).
a) Remove the locking spring of the ball joint.
b) Remove the ball joint from the gas spring.
1253 - 003 - 22.01.2020
A
B
c) Attach the ball joint to the product.
d) Attach the gas spring to the ball joint. Lock the
gas spring to the ball joint with the locking spring.
5. Lock the weight to the weight holder with the lock
ring.
To adjust the weights
WARNING: Be careful when you adjust the
weights. The moving parts can cause injury.
WARNING: Always make sure that the
weight lock locks correctly when the weights
are put in the selected position.
1. Push in the weight lock (A) and move the weight to a
selected position (B) with the weight handle. Refer to
Weights on page 16 .
A
2. Release the weight lock to lock the weight in the
selected position.
B
17