Husqvarna PG 830S Operator's Manual page 11

• Half set of diamond tools: This configuration is
applicable when a flat floor finish is not necessary.
To replace the diamond tools
WARNING: Always disconnect the power
plug before you replace the diamond tools,
to prevent accidental start.
WARNING: Use protective gloves, as
diamond tools can become very hot.
WARNING: Use approved respiratory
protection when you replace the diamond
tools. The dust below the grinding head is
dangerous to your health.
WARNING: Use the dust extractor when you
replace the diamond tools. The dust
extractor will decrease the dust that can
cause health problems.
CAUTION: All the grinding discs must
always have the same number and type of
diamonds. The height of the diamonds must
be the same on all grinding discs.
1253 - 003 - 22.01.2020
1. Turn the ON/OFF switch (A) on the control panel to
0. The LED adjacent to the ON/OFF switch goes off.
2. Push the emergency stop button (B) on the control
panel.
3. Set the handle in servicing position. Refer to
positions on page 13 .
4. If weights are installed, adjust the weights to a
rearward position. Refer to
page 17 .
5. Engage the support frame. Refer to
disengage the support frame on page 10 .
6. Hold the handlebar and with one foot on the support
frame tilt the product rearward. Tilt the product until
the handlebar is on the floor.
B
A
Handle
To adjust the weights on
To engage and
11