Maintenance - Husqvarna BMG 444 Operator's Manual

1. Push the stop button (B).
2. Keep the tool plates against the surface until they
stop fully.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
General product maintenance
Clean the product.
Do a check of all safety devices.
Make sure that nuts and screws are tight.
Do a check of the brush sealing for damages and wear.
Clean the electrical enclosure.
Do a check of the electrical components, the cables and the
connections for wear and damages.
Do a check of the hose connections. Do a check of all hoses on
the product for damages or leakage.
14
B
A

Maintenance

Before you do
3. Disconnect the power cord.
4. Stop the dust extractor.
To stop the product, control panel with
speed adjustment
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
1. Push the stop button. Refer to
control panel with speed adjustment on page 5 .
2. Keep the tool plates against the surface until they
stop fully.
3. Disconnect the power cord.
4. Stop the dust extractor.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Daily
X
X
*
*
*
*
*
Do not lift the grinding head
Do not let the product
Product overview,
Each 3
Weekly
months
1914 - 001 - 28.06.2022