Husqvarna PG 690 Propane Operator's Manual page 5

5. Warning
6. Gauge for the rpm for the engine
7. Rpm for the engine
To use the display
Use the menu button and the set button to control the
display.
1. Push the menu button quickly to move between the
selections in the display.
2. Push and hold the menu button to go to the selected
selection.
3. In the selection, push the menu button quickly to
select between ON/OFF.
4. In the selection, push the set button to adjust the
selected selection.
5. Push and hold the menu button to lock the selection
and go back to main menu.
Note: The display goes back to the main menu if you do
not use it for 10 seconds.
Display menu
Menu Information and ba-
selec- sic set
tions
Total op- Shows the time the
eration product has been
time used.
Time to Shows how many
next hours before a serv-
servicing icing is necessary.
Max rpm Shows the maxi-
mum rpm used dur-
ing last operation.
Ignition Basic set is "1P1r".
Rpm limit Set rpm range be-
tween 2400 - 3600
rpm.
Rpm Basic set is "OFF".
warning
Set is "ON", the
product gives a
warning at selected
rpm value.
1212 - 003 - 25.05.2020
Set options
N/A
Select "ON" to reset.
Select "ON" to clear.
N/A
Push the set button
quickly to add 100
rpm each time. Push
and hold the set but-
ton to add 1000 rpm
each time.
Push the set button
quickly to add 100
rpm each time. Push
and hold the set but-
ton to add 1000 rpm
each time.
Menu Information and ba-
selec- sic set
tions
Service Basic set is 100 h.
warning
The product gives a
warning when it has
been used for this
many hours.
Voltage Basic set is 11.0 V.
warning
The product gives a
warning at this volt-
age value.
Battery Shows the meas-
voltage ured voltage of the
battery in V.
Reset to Will reset the prod-
factory uct to factory set-
settings tings.
Display warning symbols
The display can show warning symbols.
• Rpm warning: The display shows a warning triangle.
• Low battery warning: The display shows the letters
LOU and a warning triangle.
• Service warning: The display shows the letters SUC
and a warning triangle.
Rpm for the engine
CAUTION: Read the instruction carefully
and make sure that you understand the
instruction before you use the product.
The display shows the rpm for the engine (A). The
gauge (B) in the display shows how much of the rpm for
the engine that is used.
A
WARNING!
DO NOT OPERATE ENGINE BETWEEN 1200 - 2600 RPM
IDLE
The gauge has 3 fields:
• "IDLE": idle speed, 0 - 1200 rpm.
• "DO NOT OPERATE": the clutch engages, 1200 -
2600 rpm.
Set options
Push the set button
quickly to add 1 h
each time. Push and
hold the set button
to add 10 h each
time.
Push the set button
quickly to add 0.1 V
each time. Push and
hold the set button
to add 1 V each
time.
N/A
Do not use.
rpm
B
DO NOT OPERATE GRIND
1200 2600 RPM
5