Second Section - For The Installer - lamber MATIC-M-MA Series Instruction Manual

MATIC-M-MA

9 - Second Section - FOR THE INSTALLER

The following instructions are addressed to qualified personnel who is the only one authorized to
carry out the inspections and the necessary repairs.
The machine should be installed in "Normal" environment that is to say, indoors, free of dust,
explosion-proof and adequately lit and well aired.
Before installing the machine, it is necessary to arrange the power and water connections.
See the reported wiring diagram (supplied by the manufacturer) of the selected model as far as
the dimensions of pipes, cables and wall-mounted switch concerns.
In order to prevent damages caused by the escape of vapours from the equipment make sure
that adjacent materials do not deteriorate in their presence.
The Manufacturer cannot assume any responsibility for any damage to persons or
property deriving from the non-observance of the above specified norms.
9.1 - DETERGENTS
Attention.
Observe the safety notes and dosage data for the use of chemicals. During the use of the
chemical substance wear protective clothing, gloves and protective glasses. Do not mix different cleaning
During the use of chemicals is advisable to wear appropriate clothing, such as gloves and
products.
protectives glasses.
The machine should also be equipped with a detergent and brightener dispenser, which shall be
supplied by the manufacturer of these products.
N.B.: If you make use of chlorinated sanitizers, it is always advisable to employ an automatic
dispenser provided with feeler for the measurement of the detergent concentration, because
brownish spots can form on the surfaces due to chlorine reactions when pouring the detergent
directly into the tank. The feeler for the measurement of concentration must be placed on the front
side of the tank through the hole "A" preset for such operation (see drawing on page 56).
In any case the LIQUID DETERGENT shall be introduced through the preset hole "B" on the
front side of the washing tank.
Choice of the suitable cleansing agent is an essential condition if you want to obtain extremely
good washing results as concerns hygienic results.
It is then important to consider some points.
First of all only highly alkaline and chlorine-active antifoam products, especially made for industrial
dish-washing machines, must be used and they must be produced by well known reliable Firms.
We provide a short list just as an indication: Ecolab-Soilax; Henkel; Lever; Diversey; Relativ.
The average concentration of liquid detergents must be 2-4g/litre. In any case it is essential that
the producer of the detergent rules the dosage properly according to the features of the
installation.
As regards the introduction of the liquid rinse aid product, use the inlet "C" , placed near the
water group.
This coupling will allow an appropriate introduction of the liquid rinse aid product.