Husqvarna 325iLK Workshop Manual page 16

3. Remove the power trigger lockout (A), digital user
interface (B) and the power trigger (C).
4. Disconnect the digital user interface.
5.4.5 To install the cable into a product with a
digital user interface
1. Make a note of the Husqvarna identification number
(HID) of the new digital user interface before you
install it. The identification number is found on the
new control unit.
2. Connect the user interface to the end of the cable
with 2 pieces of tape.
3. Put the digital user interface in the handle.
16 - Repair instructions
4. Install the cable in the handle as shown in the
B
C
A
5. Install the cable in the battery housing as shown in
6. Install the cable holder.
7. Install the power trigger and the power trigger
8. Assemble the control handle. Refer to
9. Connect the product to the common service tool
illustration.
the illustration.
To install the power trigger and
lockout. Refer to
power trigger lockout in a control handle with a
digital user interface on page 17 .
disassemble and assemble the control handle on
page 10 .
(CST) and install new firmware if you replace the
To connect the common
user interface. Refer to
service tool (CST) on page 8 .
To
726 - 002 - 23.01.2020