Husqvarna 325iLK Workshop Manual page 15

6. Remove the 2 screws on the motor bracket and
remove the motor.
7. Remove the vibration damping units (A).
8. Remove the 3 screws (B) that hold the motor
bracket (C).
C
B
9. Remove the motor bracket from the motor.
10. Install in the opposite sequence.
5.4.3 To remove and install the control unit
1. Remove the shaft. Refer to
page 11 .
2. Remove the wear guard. Refer to
install the wear guard on page 10 .
3. Disassemble the control handle. Refer to
disassemble and assemble the control handle on
page 10 .
4. Disassemble the battery housing. Refer to
disassemble and assemble the battery housing on
page 10 .
5. Remove the motor. Refer to
the motor on page 14 .
726 - 002 - 23.01.2020
A
To remove the shaft on
To remove and
To
To
To remove and install
6. Remove the screw (A) and the wire cover (B).
A
7. Remove the 2 screws (C) to loosen the battery
connector (D).
C
8. Disconnect the user interface.
9. Remove the control unit.
10. Install in the opposite sequence.
5.4.4 To remove the power trigger lockout, power
trigger and digital user interface
1. Remove the shaft. Refer to
page 11 .
2. Disassemble the control handle. Refer to
disassemble and assemble the control handle on
page 10 .
B
D
To remove the shaft on
To
Repair instructions - 15