ABB REL 551 2.3 Series Installation And Comissioning Manual page 82


76
Preparing for test
 6HOHFW µ1R¶
 3UHVV µ&¶ WZLFH WR OHDYH WKH PHQX
The 'Save TestGroup?' dialog appears.
 &KRRVH µ<HV¶ OHDYH WKH PHQX
&KHFNLQJ WKH GLVWXUEDQFH UHSRUW VHWWLQJV
The terminal must be set in testmode (Operation=ON) to activate the disturbance report
settings.
The user can select how the disturbances are indicated on the local HMI during the test.
The user can for example select if the disturbance summary should be stored, scrolled
on the local HMI or if LED information should be stored. Scroll to the disturbance re-
port settings which are located in the local HMI under:
7HVW7HVW0RGH'LVWXUE5HSRUW
7DEOH 'LVWXUEDQFH UHSRUW VHWWLQJV
2SHUDWLRQ 'LVWXUE
6XPPDU\
Off Off
Off On
On On or Off
7KHQ WKH UHVXOWV DUH
• Disturbances are not stored.
• LED information is not displayed on the HMI and not stored.
• No disturbance summary is scrolled on the HMI.
• Disturbances are not stored.
• LED information (yellow - start, red - trip) are displayed on the
local HMI but not stored in the terminal.
• Disturbance summary is scrolled automatically on the local
HMI for the two latest recorded disturbances, until cleared.
• The information is not stored in the terminal.
• The disturbance report works as in normal mode.
• Disturbances are stored. Data can be read from the local HMI,
a front-connected PC, or SMS.- LED information (yellow - start, red
- trip) is stored.
• The disturbance summary is scrolled automatically on the
local HMI for the two latest recorded disturbances, until cleared.
• All disturbance data that is stored during test mode remains in
the terminal when changing back to normal mode.
&KDSWHU 
9HULI\LQJ VHWWLQJV E\ VHFRQGDU\
LQMHFWLRQ