ABB REL 551 2.3 Series Installation And Comissioning Manual page 130






124
Two step time delayed phase overcurrent
protection (TOC2)
7ZR VWHS WLPH GHOD\HG SKDVH RYHUFXUUHQW
SURWHFWLRQ 72&
Prepare the terminal for test as outlined in section "Preparing for test" in this chapter.
Ensure that the maximum continuos current of a terminal does not exceed four times its
rated value, if the measurement od the operating characteristics runs under constant
voltage conditions.
To verify the settings the following fault type should be tested:
• One for a phase-to-earth fault
0HDVXULQJ WKH RSHUDWH DQG WLPH OLPLW IRU VHW YDOXHV
0HDVXULQJ WKH RSHUDWH OLPLW RI WKH ORZ VWHS RYHUFXUUHQW SURWHFWLRQ
3URFHGXUH
 ,QMHFW D SKDVH FXUUHQW VOLJKWO\ VPDOOHU WKDQ WKH IXQFWLRQDO YDO
XH ,!/RZ
 ,QFUHDVH WKH FXUUHQW VORZO\ DQG FKHFN WKH IXQFWLRQ YDOXH E\
REVHUYLQJ ZKHQ WKH VLJQDO 72&67/6 DSSHDUV
 &RPSDUH WKH UHVXOW RI WKH PHDVXUHPHQW ZLWK WKH VHW YDOXH
0HDVXULQJ WKH GHILQLWH WLPH GHOD\ RI WKH ORZ VHW VWDJH
3URFHGXUH
 6HW D FXUUHQW  WLPHV ,!/RZ RQ WKH LQMHFWLRQ WHVW HTXLSPHQW
 6ZLWFK WKH FXUUHQW RQ DQG FRPSDUH WKH RSHUDWLRQ WLPH RQ
72&75/6 ZLWK WKH VHW YDOXH W/RZ
The operate time shall be tLow+operate time of the low set stage.
0HDVXULQJ WKH LQYHUVH WLPH GHOD\ RI WKH ORZ VHW VWDJH
3URFHGXUH
 6HW WHPSRUDULO\ W/RZ
If I>Low is set higher than I>Inv, check that there is no trip signal
TOC2-TRLS when the current is less than I>Low.
9HULI\LQJ VHWWLQJV E\ VHFRQGDU\
 V
&KDSWHU 
LQMHFWLRQ