ABB REL 551 2.3 Series Installation And Comissioning Manual page 111



Monitoring of AC analogue
measurements
0RQLWRULQJ RI $& DQDORJXH PHDVXUHPHQWV
Stabilized ac current and voltage generators and corresponding current, voltage, power
and frequency meters with very high accuracy are necessary for testing the alternating
quantity measuring function. The operating ranges of the generators must correspond
to the rated alternate current and voltage of each terminal.
Prepare the terminal for verification of settings as outlined in section "Preparing for
test" in this chapter. Connect the generators and instruments to the corresponding input
terminals of a unit under test.
9HULI\LQJ WKH VHWWLQJV
3URFHGXUH
 6XSSO\ WKH WHUPLQDO ZLWK YROWDJHV DQG FXUUHQWV
Check that the values presented on the HMI unit correspond to the
magnitude of input measured quantities within the limits of de-
clared accuracy. The mean service values are available under the
submenu:
6HUYLFH 5HSRUW6HUYLFH9DOXHV
The phasors of up to five input currents and voltages are available
under the submenu:
6HUYLFH 5HSRUW3KDVRUV3ULPDU\
 &KHFN WKH RSHUDWLRQ RI $'%6 RU ,'%6 ZKHQ DSSOLFDEOH &RP
SDUH ZLWK WKH H[SHFWHG YDOXHV
The operation of ADBS or IDBS function can be checked sepa-
rately with the RepInt = 0 setting. The value on the HMI follows
the changes in the input measuring quantity continuously.
 &KHFN WKH VHW RSHUDWH OHYHOV RI WKH PRQLWRULQJ IXQFWLRQ E\
FKDQJLQJ WKH PDJQLWXGH RI LQSXW TXDQWLWLHV DQG REVHUYLQJ WKH
RSHUDWLRQ RI WKH FRUUHVSRQGLQJ RXWSXW UHOD\V
The output contact changes its state when the changes in the input
measuring quantity are higher than the set values HIWARN, HI-
ALARM, or lower than the set values LOWWARN, LOW-
ALARM.
&KDSWHU 
9HULI\LQJ VHWWLQJV E\ VHFRQGDU\
LQMHFWLRQ
105