保 守・点; Maintenance - FujiFilm FUJINON ZK Cabrio Series Operation Manual

Cine lens
Hide thumbs Also See for FUJINON ZK Cabrio Series:
Table of Contents

Advertisement

保 守 ・ 点 検
■ レンズの清掃
市販のレンズクリーナおよびレンズクリーニ
ングペーパーを用意します。
a. 始めに、レンズ表面のほこりを、柔らかい
ハケやブロアーブラシなどで払い落とし
ます。
b. クリーニングペーパーを適当な大きさに
折り、一部をレンズクリーナに浸します。
ペーパーの湿った部分で、レンズの中心
部から周辺部に向けて渦巻きを描きなが
ら軽く拭きます。新しいペーパーを使用し
て、拭き残りがなくなるまでこの作業を繰
り返してください。
■ 湿気の除去
レンズ本体に水分が付着した場合には、ま
ず、速やかに乾いた布で外部の水分を拭き
取ってください。次に、乾燥剤と共にビニール
袋に入れて密封し、完全に除湿してくださ
い。
■ 保 管
長期間レンズを使用しないときは、高温、多
湿、腐食性ガスのある場所を避けて保管して
ください。
■ 点 検
ご使用上不都合が生じた場合には、購入先
販売店にご相談ください。
長期間、高性能を維持していただくために、1
年に1回の定期点検をお勧めいたします。
なお、お客様のご都合で改造等が行われた
製品につきましては、点検 ・ 修理をお引き受
けできないこともありますのでご注意くださ
い。
CINE-17T/R3

MAINTENANCE

■ CLEANING THE LENS
Prepare lens cleaning liquid and lens
cleaning paper on the market.
a. First use a soft brush or blower brush
to brush dust off the surface of the lens.
b. Fold the cleaning paper to an adequate
size, and dip a part of it into the liquid.
Lightly wipe the lens from the center to
the periphery while drawing a spiral
with the wet paper part. Repeat this
operation using new paper until the
lens is thoroughly cleaned.
■ REMOVING THE MOISTURE
When the lens main body is wet, first wipe
the water on the external part with dry cloth
immediately.
Then put it together with
desiccant into a vinyl bag for sealing to
remove the moisture inside.
■ STORAGE
If it is assumed that the lens will not be
used for a long term, store it in a place
where high temperature, much moisture or
corrosive gas is absent.
■ INSPECTION
If an abnormality occurs on the lens,
contact the sales agent from which you
purchased the lens.
To maintain the high performance for a
long term for use, we recommend that a
periodic inspection is conducted at least
once a year.
Note that we may not be able to inspect
and repair our products which have been
remodeled on the user's end.
- 10 -
保 养 / 点 検
■ 清洁镜头
在市场上购买镜头清洁液和镜头清洁纸。
a. 首先使用柔软毛刷或气刷清除镜头表面
的灰尘。
b. 将镜头清洁纸折成合适大小,然后浸入
清洁液。将湿水部分卷成螺旋状,轻轻
由中间向四周擦拭镜头。使用新的镜头
清洁纸重复这项操作,直至镜头彻底清
洁。
■ 消除水汽
镜头主体受湿后, 首先立即用清洁干布擦除
镜头外部的水。 然后与干燥剂一起封入塑料
袋中以消除内部的水汽。
■ 保 存
如果镜头长时间不使用时,应避开高温、潮
湿或有腐蚀气体的环境保存。
■ 检 查
如果镜头出现异常情况, 请联系我们的销售
代理商。
为了长期保持产品的高性能, 建议您定期检
查,至少每年一次。
请注意, 我们可能无法检查和修理用户改装
过的产品。

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents