Chapter Iv Functional Parameters - HNC Electric HV610 Series User Manual

F0 - 46 is set to a value other than 0, i.e. the parameter protection password is set. In the function parameter mode
and the user change parameter mode, the parameter menu cannot be entered until the password is correctly entered.
To cancel the password, F0 - 46 needs to be set to 0.
Group F and group P are basic functional parameters, and group U is monitoring functional parameters.
4.1 Summary of basic functional parameters
Function
code
F0-00 Menu mode selection
F0-01 Control operation mode
Run command channel
F0-02
selection
Main frequency source X
F0-03
selection
F0-04 Anti - reverse selection
Phase sequence
F0-05
selection
Operation selection
F0-06
when power is on
JOG.K key function
F0-07
selection

Chapter IV Functional parameters

Name
F0 group basic functions
Bits: monitoring group U0
0: Not displayed
1: Display
Ten digits: special parameter group P
0: Not displayed
1: Display
0: No PG open loop vector control
1: PG closed loop vector control
2: V/F control
0: Operation panel
1: Terminals
2: Communication
0: Number setting 1
1: Number setting 2
2: AI1
3: AI2
4: AI3
5: X5 pulse given
6: Multi-segment instruction
7: Simple PLC
8: PID
9: Communication given
10: Potentiometer for keyboard given
0: Allowed
1: Forbidden (0 frequency operation when
reverse command is applied)
0: Standard
1: Carry out phase sequence exchange.
(rotation direction changes)
0: Allowed (when the power supply is turned on
and there is an operation command, the
operation will start.)
1: Prohibit (even if there is an operation
command while the power supply is on, the
motor selection is also prohibited.)
0: JOG.K is invalid
1: Operation panel command channel and
remote command channel ( terminal command
channel or communication command channel )
switch
2: Forward and reverse switching
3: Inching forward
4: Reverse inching
Setting range
21
Factory Communica
value tion address
11 F000H
2 F001H
0 F002H
1 F003H
0 F004H
0 F005H
0 F006H
0 F007H