U0 Group Monitoring Parameter Group - HNC Electric HV610 Series User Manual

The U0 parameter group is used to monitor the operation status information of the frequency inverter.
Customers can check it through the panel to facilitate on-site commissioning. They can also read the parameter
group values through communication for monitoring by the upper computer. The communication address is 0x7000 ~
0x7044.
U0-00
U0-01
Display the absolute values of the theoretical operating frequency and the set frequency of the frequency inverter.
See U0 - 19 for actual output frequency of frequency inverter.
U0-02
Display the inverter bus voltage value.
U0-03
Display the output voltage value of the frequency inverter during operation.
U0-04
Display the output current value of the frequency inverter during operation.
U0-05
Display the output power value of the frequency inverter during operation.
U0-06
Display the output torque value of the frequency inverter during operation.
U0-07
Display the current X terminal input status value. After being converted into binary data, each bit corresponds to
X input signal, a value of 1 indicates that the input is a high level signal, and a value of 0 indicates that the input is a
low level signal. The correspondence between each bit and the input terminal is as follows:
Bit0
X1
Bit4
X5

U0 Group monitoring parameter group

Running frequency
Set frequency
Busbar voltage
Output voltage
Output current
Output power
Output torque
X terminal input status
Bit1
X2
Bit5
X6
Indication range
Indication range
Indication range
(frequency inverter power < = 55kw )
Indication range
(frequency inverter power > 55kw )
Indication range
Indication range
Indication range
Bit2
X3
Bit6
X7
121
0.00：500.00Hz
0.0V～3000.0V
0V～1140V
0.00A～655.35A
0.0A～6553.5A
0～32767
-200.0% - 200.0%
0～32767
Bit3
X4