Fd Group Communication Parameters; Fe Group User Customized Function Code; E0 Group Fault Record - HNC Electric HV610 Series User Manual

Please refer to appendix a: description of communication parameters of FD group.
This group function code is a user-defined parameter group.
The user can select the required parameters from all HV610 function codes and summarize them to the Fe
group as user-customized parameters.
Number to facilitate viewing and changing operations The Fe group provides up to 30 user-defined parameters,
and the displayed value of the Fe group parameter is f 0.00, which indicates the user function code is empty.
When entering the user-defined parameter mode, the display function codes are defined by FE-00～FE-31. The
order is the same as that of the FE group function codes. If F0 - 00, it will be skipped.
FF - 04 cbc current limiting enable
0: not enabled.
1: enabling wave-by-wave current limiting.
By enabling the wave-by-wave current limiting function, the over-current fault of the frequency inverter can be
minimized and the frequency inverter can be guaranteed to run uninterruptedly.
FF – 06 Uder voltage point setting
Voltage value of frequency inverter under voltage fault LV
FF – 09 over voltage point setting
Note: the factory value is also the upper limit value of the internal over voltage protection of the frequency
inverter. This parameter setting will only take effect if the FF - 09 setting value is less than the factory value. If it is
higher than the factory value, the factory value shall prevail.
E0-00 First failure type
E0-01 Second failure type
E0-02 Third ( most recent ) fault type
E0-03 Frequency at third failure

FD Group communication parameters

FE Group user-defined function code
FF Group control optimization parameters

E0 Group fault record

0～1【0】
60%～140%【100.0%】
200.0V～2200.0V【820.0V】
0～99【0】
0～99【0】
0～99【0】
0.00～500.00【0.00HZ】
117