Omron NXR Series User Manual page 69

4
Mount the M12 attachment on the M12 screw connector of the I/O cable. After you mount the
M12 attachment, rotate the M12 torque handle in the direction shown in the following figure to
tighten the M12 screw connector to the specified torque.
M12 torque handle
M12 attachment
Procedure for Disconnecting an I/O Cable
Use the following procedures to disconnect an I/O cable. Turn OFF the Unit/input power supply and
output power supply to the IO-Link Master Unit before you remove an I/O cable.
1
Insert the M12 torque handle into the tightening hole of the M12 attachment. When you remove
the connector, place the M12 attachment upside down, that is, in the opposite orientation to
that for tightening.
Hole of the M12 attachment
2
Mount the M12 attachment on the M12 screw connector of the I/O cable. After you mount the
M12 attachment, rotate the M12 torque handle in the direction shown in the following figure to
loosen the M12 screw connector.
NXR-series IO-Link I/O Hub User's Manual (W620)
M12 screw connector
M12 torque handle
5 Installation and Wiring
5
5-9