5 Installation and Wiring
2
Rotate the M12 screw connector of the I/O cable in the direction shown in the following figure
to tighten it. Tighten the connector before tightening it to the specified torque.
3
Set the M12 torque handle to the specified torque. Then, insert the torque handle into the tight-
ening hole of the M12 attachment. When you tighten the connector, place the M12 attachment
in the orientation shown in the following figure and insert the torque handle.
Refer to 5-2-5 Tightening Torque on page 5-10 for information on the specified torque.
M12 torque handle
5-8
M12 screw connector
Hole of the M12 attachment
NXR-series IO-Link I/O Hub User's Manual (W620)