Assembling And Setting Up The Double Grinder; Attaching The Grinder To The Work Bench Or A Support - Westfalia 83 79 06 Instruction Manual

Assembling and Setting up the Double Grinder

Before undertaking any work on the machine, pull the power plug.
1. Before start-up the visor and the spark
deflector must be attached to both grinding
wheels.
2. The work piece support (3) must not be
further away from the grinding wheel than
2 mm.
3. Check this distance regularly while using
the grinder because the diameter of the
wheel decreases over time during use.
4. Next, install the spark deflector. The spark
deflector should be mounted as close to
the wheel as possible.
5. The visor and its holder are mounted to the
inners side of the hood with the long hex
crew (15) and the retainer (17).

Attaching the Grinder to the Work Bench or a Support

1. To attach the grinder use M8
screws which are approximately 20
– 25 mm longer than your work top
is thick.
2. Drill two holes 140 mm apart
through the work top. Insert the
screws into the holes from above.
Place the grinder on the work top in
such a way that the screw heads
with their washers engage into the
slots in the sides of the foot of the
grinder.
3. Secure the screws from below with
a washer, a spring washer and an
M8 nut.
Operation
11
5
15
11
14
9
16
3