Table of Contents
Advertisement
Warning
CAUTION
In order to prevent damage, the drive
DRIVESHAFT MUST BE LUBRICATED
PRIOR TO START UP AND EVERY
12 MONTHS FOLLOWING WITH A
shaft must be lubricated regularly with
N.L.G.I GRADE 1 OR 2 GREASE.
REFER TO OPERATOR AND MAINTENANCE
the correct lubricant.
MANUAL FOR CORRECT PROCEDURE.
C13258
Warning
CAUTION
Do not let the engine run without an air
DO NOT RUN ENGINE WITHOUT
filter.
AIR FILTER INSTALLED.
PERSONAL INJURY OR
This may cause personal injury or
ENGINE DAMAGE MAY
RESULT.
C13191
damage to the engine.
WARNING
Warning
LIFTING BRACKET
This lifting point is only for lifting the
IS FOR ENGINE ONLY
engine, not the entire fire pump set.
C13186
Warning
Hazardous voltages are present in this
Hazadous voltages are present
enclosure. Improper use or failure to
inside this enclosure. Serious
injury, electrocution and/or
equipment damage will result of
take precautions can cause serious
improper application or if
precaution is not used.
Disconnect all supply sources
injury, electric shock and/or damage
(including any foreign circuits)
before working om controller,
motor(s) or pump(s).
to the equipment.
Only qualified personnel should
work on or around this
equipment.
Lifting points for the entire fire pump set.
2. Applications
The Grundfos Fire HSEF and DNF pump sets are designed for
fire systems for supplying water to hose reels, fire hydrants and
sprinkler systems.
Warning
The fire pump set must only be used for the
applications mentioned. Any other use is
considered improper use. Grundfos cannot be
held responsible for damage caused by improper
use. The liability rests solely with the operator.
The Grundfos Fire HSEF and DNF pump sets with diesel engine
must not be used for ordinary pumping of liquids or common
pressure boosting in daily work. They should only be used for fire
fighting.
The pump controller must not be used as a junction box for
supplying other equipment.
4
3. Delivery, transport, storage
Check the fire pump set carefully on delivery
against the papers and inspect for damage
incurred during transport. Immediately notify the
Note
carrier of any damage or shortage found.
Transport and store it correctly before
installation.
3.1 Delivery
The fire pump set is delivered from factory in an open wooden
box or wooden/cardboard box which is specifically designed for
transport by fork-lift truck or similar device.
3.2 Transport
For lifting the entire fire pump set, use the lifting holes of the base
frame. When lifting, the lifting point should always be above the
centre of gravity of the fire pump set. See fig. 1.
Warning
Lifting the fire pump set should only be done by
qualified personnel.
When lifting the entire fire pump set, never use
the lifting eyes of the individual components.
Use only suitable lifting equipment in proper
condition. See also weight specifications in
section 7. Technical data.
During transport of the fire pump set, the cabinet
door must be closed and locked.
Do not stand or place hands under a component
in such a way that the component would fall on
the hands if dropped.
Correct lifting of fire pump set
Fig. 1
Advertisement
Table of Contents
