Continuity Test - Wetekom 9804 Instruction Manual

4.5 Continuity Test Function
With this function you can check circuitry, cables or components for continuity.
Important Notice!
Do not perform continuity tests on voltage-carrying components or circuitry.
Procedure
1. Set the rotary function switch (3) to the position "
Display the correct measuring inputs are indicated as filled symbols
(20).
2. Connect the red probe to the V/Ω/
to the COM input (10).
3. Make sure the component or circuit to be measured is voltage-free.
4. Connect the probes to the component or circuitry you intend the
measure.
5. If the resistance is under 50 Ω a signal sound, which indicates the
component or circuitry is continuous, can be heard and the measured
resistance value is displayed. This indicates that the component is
continuous.
4. Taking Measurements
input (9) and the black probe
34
/
". In the