Preparing The Board - Motorola MVME177P Installation And Use Manual

Hardware Preparation and Installation
1
!
Warning

Preparing the Board

1-4
Turn the system's power off before you perform these procedures. Failure
to turn the power off before opening the enclosure can result in personal
injury or damage to the equipment. Hazardous voltage, current, an denergy
levels are present in the chassis. Hazardous voltages may be present on
power switch terminals even when the power switch is off. Never operate
the system with the cover removed. Always replace the cover before
powering up the system.
To produce the desired configuration and ensure proper operation of the
MVME177P, you may need to reconfigure hardware to some extent before
installating the board.
Most options on the MVME177P are under software control: By setting
bits in control registers after installing the module in a system, you can
modify its configuration. (The MVME177P registers are described in
Chapter 3 under ENV – Set Environment, and/or in the Programmer's
Reference Guide as listed under "Related Documentation" in Appendix E.)
Some options, though, are not software-programmable. Such options are
either set by configuration switches or are controlled through physical
installation or removal of header jumpers on the base board.
Computer Group Literature Center Web Site