Table of Contents
Advertisement
Preparing for Installation
Preparing for Installation
Prepare for installation by following these steps:
•
Take Antistatic Precautions
•
Unpacking Kit Contents
•
Environmental Requirements
•
Power Requirements
Take Antistatic Precautions
When handling circuit boards and associated internal computer components, use an antistatic
wristwrap or wear isolation gloves.
Caution Circuit boards and associated system components are sensitive to and can be damaged
by ESD. To avoid damaging boards or components, take appropriate precautions when
handling them.
In addition to using an antistatic wristwrap or wearing isolation gloves, consider the following
precautions:
•
Do not allow a circuit board or other components to make contact with nonconductors,
including your clothing.
•
Keep loose circuit boards inside or on top of conductive plastic bags.
•
Before touching a loose circuit board or component, discharge static electricity.
Unpacking Kit Contents
To unpack kit contents:
1. Locate and put on an antistatic wristwrap.
2. Clip the wire attached to the wristwrap to the frame of your system chassis.
3. Verify that the order numbers on labels of your kit carton match the numbers for
the product you ordered. If the order numbers do not match, contact your local
sales representative.
4. Remove all items from the carton.
5. Remove the hardware components from the conductive plastic bags in which they
were packaged and place the components on the bags.
42
All manuals and user guides at all-guides.com
Installation
IXP/CPCI-9120
Advertisement
Table of Contents
