System Considerations - Motorola MVME177P Installation And Use Manual

8. Connect the P2 adapter board or LCP2 adapter board and cable(s) to
9. Connect the appropriate cable(s) to the panel connectors for the
Note
10. Connect the peripheral(s) to the cable(s).
11. Install any other required VMEmodules in the system.
12. Replace the chassis cover.
13. Connect the power cable to the AC power source and turn the

System Considerations

The MVME177P draws power from VMEbus backplane connectors P1
and P2. P2 is also used for the upper 16 bits of data in 32-bit transfers, and
for the upper 8 address lines in extended addressing mode. The
MVME177P may not operate properly without its main board connected
to VMEbus backplane connectors P1 and P2.
http://www.motorola.com/computer/literature
MVME177P backplane connector P2. This provides a connection
point for terminals or other peripherals at the EIA-232-D serial
ports, parallel port, SCSI port, or LAN Ethernet port. For
information on installing the P2 or LCP2 Adapter Board and the
MVME712 series transition module(s), refer to the corresponding
user's manuals (the Programmer's Reference Guide provides some
connection diagrams).
serial and parallel ports, SCSI port, and LAN Ethernet port.
– Note that some cables are not provided with the MVME712
series transition module and must be made or purchased by the
user. (Motorola recommends shielded cable for all peripheral
connections to minimize radiation.)
Some cables are not provided with the MVME712 series module;
they must be made or purchased by the user. (Motorola
recommends shielded cable for all peripheral connections to
minimize radiation.)
equipment power ON.
Installation Instructions
1-13
1