Instructions For Continued Airworthiness - EMS eNfusion 1252-A-4100-01 System Description, Installation And Maintenance Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
400 Maple Grove Road
Ottawa, Ontario
Canada K2V 1B8
RMA#__________
Attn: Repair & Overhaul
6. Fax or email the details of the shipment to the R&O Coordinator, including the
following information: Shipment date, carrier name and the waybill number.
NOTE: The processing of LRU returns is limited to standard business hours from
Tel: 613-591-6040 Ext. 1214
Fax: 613-591-8951
Email: rmareturns@emssatcom.com
3.

Instructions for Continued Airworthiness

This section presents the instructions for continued airworthiness, as per FAR 25.1529, of the
HSD-X and HSD-Xi terminal.
Installation of the HSD-X and HSD-Xi terminal on an aircraft by supplemental type certificate
(STC) or Form 337 obligates the aircraft operator to include the maintenance information
supplied by this manual in the operator's Aircraft Maintenance manual and the operator's
Aircraft Scheduled Maintenance Program.
The following paragraphs describe all maintenance requirements and instructions for
continued airworthiness of the HSD-X and HSD-Xi terminal.
• Add the LRU part numbers and other necessary part numbers contained in this manual
to the aircraft operator's appropriate, aircraft illustrated parts catalog (IPC).
• Add all wiring diagram information contained in this manual to the aircraft operator's
appropriate aircraft Wiring Diagram Manuals.
• HSD-X and HSD-Xi terminals are considered on-condition units. No additional or routine
maintenance is required.
• If an HSD-X and HSD-Xi terminal is inoperative, remove the terminal, secure cables and
wiring, collar applicable switches and circuit breakers, and placard them as inoperative.
Before flight, revise the equipment list and weight and balance data as applicable and
record the removal of the terminal in the log book [refer to section 91.213 of the FAR or
the aircraft's minimum equipment list (MEL)].
• HSD-X and HSD-Xi terminals are not field-repairable. All terminals must be returned to
the EMS SATCOM factory or authorized repair centers for repair.
• Repaired terminals must be re-installed on the aircraft in accordance with the instructions
provided in this manual. The operation of all repaired terminals must be verified using the
operational verification tests and procedures provided in this manual before being
approved for return to service. All special tools required to test the terminal for approval
for return to service are listed and described in "Test and Fault Isolation" on page 4-1.
8:30 am to 5:00 pm EST. For General inquires and status requests, please
contact the R&O department directly:
23-15-30
5-10
8 MAY 09