Disconnecting The Load Equipment; Repair; Repair Tools And Supplies; Repair Procedures - EMS eNfusion 1252-A-4100-01 System Description, Installation And Maintenance Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
7. Verify that all software has loaded successfully to both channel cards. Verify that
the firmware versions shown match the versions listed on the load disk (or files)
and in the software service bulletin (examples shown above).
8. Close the terminal emulation program.
9. Remove power from the HSD-Xi terminal.
This completes the software load verification.

(4) Disconnecting the Load Equipment

You must complete all required software loads and load verification before you
disconnect the load equipment.
To disconnect load equipment:
1. Remove power from the HSD-Xi terminal (if applicable).
2. Turn off the computer (if applicable).
3. Disconnect the serial cable connector from the COM port.
4. Disconnect the serial cable connector from the HSD-Xi terminal maintenance port.
2.

Repair

All repair procedures must be completed by EMS SATCOM-approved repair facilities.
A. Repair Tools and Supplies
No special supplies are required to repair this equipment.
HSD-X and HSD-Xi terminals that require service must be returned to EMS SATCOM or
to an EMS SATCOM-approved service center. Refer to "Test and Fault Isolation" on page
4-1 for terminal testing requirements and procedures.
B. Repair Procedures
This equipment does not require any special repair procedures.
C. Removal Procedures
If an HSD-X and HSD-Xi terminal must be removed from service for repair, remove power,
disconnect all equipment from the terminal and then remove it from the ARINC tray.
D. Repair Facility Approvals
EMS SATCOM, located at 400 Maple Grove Road in Ottawa, Ontario, Canada, is a
Transport Canada Approved Maintenance Organization (AMO). In accordance with the
Technical Arrangement on Maintenance between Canada and the European aviation
authority JAA, and due to the Bilateral Agreement between Canada and the United States
aviation authority FAA, EMS SATCOM conforms to the maintenance requirements of JAR
145 and FAR 145 respectively.
23-15-30
5-8
8 MAY 09