Verifying Software Loads - EMS eNfusion 1252-A-4100-01 System Description, Installation And Maintenance Manual

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-X and HSD-Xi High-speed Data Terminal
8. To load application software, type 24.
9. Press ENTER.
The system prompts you for a filename.
NOTE: The filename follows the format li_XX.bin.
10. Type the filename of the software.
11. Press ENTER.
The program prompts you to select a COM port.
12. Type the COM port connected to the HSD-Xi terminal, and then press ENTER.
13. To start the load, press ENTER.
A percentage (%) progress indicator appears on the screen. A confirmation
message briefly appears on the screen indicating that the file has been
successfully loaded, and the DOS window closes. This completes the software
load.
When you finish loading all the software load, make sure the software loaded successfully
by following "Verifying Software Loads" on page 5-7
If a software load fails, restart the load from the beginning of the procedure. If, after two
attempts, the load still does not complete successfully, contact EMS SATCOM Product
Support for assistance.

(3) Verifying Software Loads

After loading all software as specified in the applicable software service bulletin
released by EMS SATCOM verify that all software loaded successfully.
NOTE: The screens shown in this procedure are examples only. The software and
other versions may differ from your terminal.
To verify software loads:
1. Apply power to the HSD-Xi terminal.
2. On the computer, open a terminal emulation program, such as HyperTerminal,
and start the HSD-Xi terminal MPU.
3. Connect the computer to the maintenance port of the HSD-Xi terminal.
4. Type maint, and then press ENTER.
Menu 1 appears.
5. To scroll to Menu 2, press CTRL+N.
6. To display the versions of software loaded onto the HSD-Xi terminal, press V.
A list of firmware versions appears similar to the example provided below (actual
versions will differ depending on the software installed on the terminal).
FIRMWARE VERSIONS:
KERNEL:
APPLICATION:
CHANNEL CARD #1:
CHANNEL CARD #2:
DATA I/O CARD:
V1.4 -- Wed Feb 21 08:58:08 2007
V11.9 -- Wed Mar 28 10:07:24 2007
4.9.8.0 -- 0.3.6.2 -- 2.1.0.0 -- 2.7.0.0
1.17.0.1 -- -- -- 2.7.0.0
Version 1.39.0.0 built on Feb
23-15-30
2 2007 13:
5-7
8 MAY 09