Operation; Operating The Sauna Heater; Finnish Sauna Mode - Harvia sentiotec Home combi Instructions For Installation And Use Manual

Instructions for use for the user

6. Operation

WARNING!
Risk of fire
Combustible objects that are placed on the heater will ignite and cause
fires.
● NEVER place combustible objects on the sauna heater.
● Make sure that NO flammable objects have been placed on the heater
before operating it.

6.1. Operating the sauna heater

A sauna control unit is used to operate the sauna heater. For information on how
to operate the sauna control unit, read the operating instructions for the device
used. Please note that only sauna control units without a remote start function
are permitted for use with the Home combi sauna heater.

6.2. Finnish sauna mode

In Finnish sauna mode, only the heating system operates. Dry heat is produced.
The temperature in the cabin is high (80 to 100 °C). The maximum humidity level
of 10% is low. The temperature in the sauna cabin is regulated by your sauna
control unit.
At the end of the sauna session, you can pour an infusion of water over the stones.
Pour water over the stones using a sauna ladle. The water evaporates and
the humidity in the sauna cabin increases.
When pouring water over the stones, observe the following points:
● Only use tap water. Sea water, hard water and chlorinated water can damage
the sauna heater.
● Only use fragrances and essential oils that are suitable for use in saunas. Follow
the manufacturer's instructions on the packaging of the scented substance.
● Do not pour the water onto the stones too quickly. Only this way will all the
water evaporate completely.
p. 18/26