Maintenance; Extended Periods Of Non-Use; Cleaning The Sauna Heater - Harvia sentiotec Home combi Instructions For Installation And Use Manual

Instructions for use for the user
Using fragrances
If you wish, you can put liquid fragrances or dried herbs on the soapstone.
Observe the following points:
● Do not put fragrances directly into the evaporator tank.
● Carefully fill the trough in the soapstone, but only half full, so that the fragrances
do not drip through the holes in the evaporator tank.
● Follow the manufacturer's instructions on the packaging of the herbs and
fragrances.
● Regularly clean the soapstone under running water.

7. Maintenance

7.1. Extended periods of non-use

Moisture can accumulate in the heating rods in humid ambient conditions or during
long periods of non-use. This is a physical process and not a manufacturing fault.
Accumulation of moisture in the heating rods can lead to the FI circuit breaker
being triggered. In this case, contact an electrician to have the fault corrected
(see section 9. Problem-solving by the installer on page 24).
Heat the sauna heater for approximately 15 minutes every 5 to 6 weeks.
This prevents moisture from building up on the heating rods during ex-
tended periods of non-use.

7.2. Cleaning the sauna heater

Make sure that the ventilation openings are free of lint and dust. This prevents
the air circulation in the sauna heater from being restricted and prevents the de-
vice from overheating.
p. 21/26
EN