Table of Contents
Advertisement
DUOMAT 3 CARE EASY
6.2.4
Optional variant: Route the connection cable through the strain relief
Routing the connecting cable through the mounted cable grip
Figure 10
1 Take a loop of the connecting cable and guide it through the strain relief cable grip, as shown in
Figure 10.
2 Pull the cable slightly forward.
3 Put the cap onto the cable grip. The cap must snap on properly.
6.2.5
Electrical connection
Electrical components should be connected or disconnected only when the power sup-
ply cord (connecting cable) is unplugged.
NOTICE
There is a delay after the supply voltage is applied before the device actually turns on.
Wait at least seven seconds before start up.
Routing the electrical cables
When routing the cables, be sure that:
• the cables cannot get jammed,
• no mechanical load (such as pulling, pushing or bending) will be put on the cables, and
• the cables cannot be damaged in any way.
Fasten all cables (especially the mains cable) to the end product using sufficient strain relief and
kink prevention methods. Be sure that the design of the end product prevents the mains cable from
coming into contact with the floor during transport.
78668(-)
Routing the connecting cable through the mounted cable grip
CAUTION
Installation
21
Advertisement
Table of Contents
