RAB GOTCHA PLUS GT500 Installation Instructions Manual

INSTRUCTIONS
GOTCHA PLUS INSTALLATION
®
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
SPECIFICATIONS
GT500:
Voltage: 120V–277VAC, 60Hz
UL Listing: Suitable for wet locations, raintight.
Time Adjustment: 5 sec. to 15 min.
Test Mode: Set Time Adjustment Knob on sensor to Test Mode
Switching Capacity:
500W @120VAC Tungsten
500W @277VAC Tungsten
600W @120VAC Electronic Ballast (LED)
1350W @277VAC Electronic Ballast (LED)
Power Consumption: 4 Watts
Surge Protection: 6 kV
Operating Temperature: -4°F to 104°F (-20°C to 40°C)
Detection Zone: 110° by 50' at 8' mounting height
Warm Up Period: 60 seconds
Sensitivity Adjustment: 100% to 50%
Sensor Construction: Watertight, precision-molded polycarbonate
Sensor Adjustment: +/- 20° pan and tilt
GT500R:
PAR Holder Construction: Precision molded polycarbonate
with molded gasket
Cover Plate Construction: Die-cast aluminum universal
coverplate for surface or recessed junction box mounting
Sockets: Medium Base
Lamps: 150W Max PAR 38, not supplied
GT500 GT500R
CONTENTS
GT500 contents: (Fig 1)
1. (3) Wire Nuts
2. Sensor
GT500R contents: (Fig 2)
1. Sensor assembled with (2) PAR holders with molded gaskets
on a universal cover plate, wired.
2. Plate with foam gasket
3. EZ Hang "S" Hook
4. Crossbar
5. Mounting screws, ground screw, plastic fi nishing cap
6. (3) Wire Nuts
Fig: 1
Fig: 2