Prestart Inspection Checklist - Snorkel AB46JE Operator's Manual

Prestart Inspection Checklist

Item
Operator's Manual
Electrical System
Batteries
Battery fluid level and terminals
Battery charger and condition indicator
Cables and wiring harness
Hydraulic System
Fluid level
Fluid filter
Hoses, tubes and fittings
Tires
Foam filled
Wheels
Lower Control Station
Operating controls
Emergency stop and emergency power
Level Sensor
Flashing Light
All Motion Alarm
Structures
Weldments – Chassis, turntable, booms, platform, etc. Welds intact, no damage or deformation
Slide pads
Fasteners
Upper Control Station
Guardrail system and lanyard anchors
Operating controls
Emergency stop and emergency power
Horn
Electrical power outlet – GFCI
Placards and Decals
AB46JE – 0260072
Chapter 8 – Prestart Inspection
Inspect For
In place, all pages readable and intact
Condition and charged for proper operation
Proper level/clean, connectors tight
Proper operation
No wear or physical damage
Between full and add marks
Verify operation in the green zone
No leaks
Good condition
All wheel lug nuts present and properly torqued
Proper operation
Shuts off lower controls/proper operation
Sounds tilt alarm
Proper operation
Sounds when machine is operated and/or driven
In place, no damage or deformation
In place and tight
Welds intact, no damage or deformation
Proper operation
Shuts off upper controls/proper operation
Sounds when activated
Proper operation
In place and readable
Ok
37